– Receiver type 72-channel u-blox M8 engine
– GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1
– SBAS L1 C/A: WAAS, EGNOS, MSAS
– Galileo-ready E1B/C (NEO-M8N)
– Nav. update rate1 Single GNSS: up to 18 HZ
– Concurrent GNSS: up to 10 Hz
– Position accuracy2 2.0 m CEP
– Acquisition2 Cold starts: 26 s
– Aided starts: 2 s
– Reacquisition: 1.5 s
– Sensitivity2 Tracking & Nav: -167 dBm
– Cold starts: -148 dBm
– Hot starts: -156 dBm
– Assistance AssistNow GNSS Online
– AssistNow GNSS Offline (up to 35 days)3
– AssistNow Autonomous (up to 6 days)
– OMA SUPL & 3GPP compliant
– Oscillator TCXO (NEO-M8N/Q),
– Crystal (NEO-M8M)
– RTC crystal Built-In
– Noise figure On-chip LNA (NEO-M8M). Extra LNA for
– lowest noise figure (NEO-M8N/Q)
– Anti jamming Active CW detection and removal. Extra
– onboard SAW band pass filter (NEO-M8N/Q)
– Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N)
– Supported antennas Active and passive
– Odometer Travelled distance
– Data-logger For position, velocity, and time (NEO-M8N)
– Operating temp. -40° C to 85° C
– Storage temp. -40° C to 85° C (NEO-M8N/Q)
– -40° C to 105° C (NEO-M8M)
– RoHS compliant (lead-free)
1x Ublox NEO-M8N GPS Module Built-in Compass
– 1x Black GPS Holder
The GPS light only can light up when it search the satellite signal outdoor.
ROM already been fix，it cannot be flash and change.We left a connector for APM extra,If you need used for APM, you can install the connector by yourself.
★Readytosky Ublox NEO-M8N GPS Module for PX4 Pixhawk V2.4.6 V2.4.8 Flight Controller with Case and GPS Antenna Mount
★The ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy.
★A new generation Ublox GPS NEO-M8N,with low power consumption and high precision.
★The GPS light only can light up when it search the satellite signal outdoor; ROM already been fix,it cannot be flash and change.
★ Special designed for Pixhawk V2.4.6 V2.4.8 flight controller.Note:If you use it to APM Flight Controller, Please replace the connect by yourself.